W169QVN003-A-CT is 1.69 inch tft lcd display module with 4-Line SPI interface and ips all viewing angle screen. Customization is available. The shape is a rectangle with resolution 240*280. Outline dimension is 33.27 X 40.63mm, thickness is 3.35mm. Active area is 27.97 X 32.63 mm. This lcd display is coming out with 24 pins definition. LCD driver IC is ST7789V2. Working temperature is -20 to 70℃, storage temperature is -30 to +80℃. Non-Touch is optional.
DRAWING
SPECIFICATIONS
General Specification | |
---|---|
Part No. | W169QVN003-A-CT |
LCM Outline Dimension(mm) | 33.27(H) X 40.63(V) X 3.35(T) |
Active Area(mm) | 27.97 (H) X 32.63 (V) |
Number of Pixel(pixels) | 240 X(RGB)X 280 |
Touch panel | with |
Operating temperature(°C) | -20 ~ 70℃ |
Storage temperature(°C) | -30 ~ 80℃ |
Interface | SPI 4line |
Driver IC | ST7789V2 |
Pixel Configuration | RGB Stripe |
Backlight | White LED |
Viewing Direction | All o'clock |
Luminance | 300nits |
Display Mode | Normally Black, Transmissive |
Pins Description | ||
---|---|---|
PIN NO. | Symbol | Description |
1 | VDDIO | Analog power supply, 1.8V. |
2 | VDD | Analog power supply, 2.8~3.3V. |
3 | TE | Tearing effect signal is used to synchronize MCU to frame memory |
4 | SDA | SPI interface input pin |
5 | D/CX | Display data/command selection pin in 4-line serial interface. |
6 | SCL | This pin is used to be serial interface clock. |
7 | CS | Chip select signal |
8 | RESET | This signal will reset the device and it must be applied to properly |
9 | VDDIO | Analog power supply, 1.8V |
10 | VDD | Analog power supply, 2.8~3.3V |
11-12 | NC | NO connect |
13-14 | LEDK | Backlight cathode. |
15-16 | LEDA | Backlight anode. |
17 | TP-INT | Interrupt request to the host, 1.8V. |
18 | TP-SDA | TP data input and output , 1.8V. |
19 | TP-SCL | This pin is used to be serial interface clock. , 1.8V |
20 | TP-RES | This signal will reset the device and it must be applied to properly |
21-24 | GND | POWER GROUND. |